COMPUTER SIMULATION OF ISOTHERMAL FORMING PROCESS OF ALUMINUM-ALLOY FIGURINE-SHAPED PANELS
https://doi.org/10.17073/0021-3438-2013-2-84-93
Abstract
Isothermal bulk forming of AMg6 aluminum alloy blanks to produce irregular shape parts has been investigated with DEFORM-3D software. The following boundary conditions were used for the simulation: strain rate of 0,03 mm/s, strain resistance of 60 MPa, friction coefficient of 0,1. The computer model is shown to describe correctly real fabrication process of isothermal bulk forming, thus allowing us to recommend this program for designing the fabrication process to produce die forgings of irregular shape from aluminum alloys.
About the Authors
I. L. Konstantinov
Сибирский федеральный университет, г. Красноярск
Russian Federation
Russian Federation
I. Yu. Gubanov
Сибирский федеральный университет, г. Красноярск
Russian Federation
Russian Federation
Yu. V. Gorokhov
Сибирский федеральный университет, г. Красноярск
Russian Federation
Russian Federation
References
1. Чумаченко Е.Н., Смирнов О.М., Цепин М.А. Сверхпластичность: материалы, теория, технологии (Синергетика: от прошлого к будущему). М.: КомКнига, 2005.
2. Константинов И.Л., Белокопытов В.И., Горохов Ю.В., Катрюк В.П. // Сб. матер. 7-й Междунар. науч.-техн. конф. / Под ред. В.Е. Кислякова. Красноярск: ИПК СФУ, 2009. Ч. 2. С. 221.
Review
For citations:
Konstantinov I.L., Gubanov I.Yu., Gorokhov Yu.V. COMPUTER SIMULATION OF ISOTHERMAL FORMING PROCESS OF ALUMINUM-ALLOY FIGURINE-SHAPED PANELS. Izvestiya. Non-Ferrous Metallurgy. 2013;(2):46-50. (In Russ.) https://doi.org/10.17073/0021-3438-2013-2-84-93
Views:
976
Email this article 